Poor heat dissipation performance of radiator The radiator is the cooling device of the cooling system. It should be ensured that there is enough heat dissipation area against the wind. After the engi...
Maintenance Points Of Pulley Radiator 1.During disassembly and assembly, pay special attention to water leakage caused by collision. The installation position must meet the requirements of the origina...
All different types of belts in a typical engine The belt is a simple component, but it plays an important role in the operation of the engine. In short, the belt provides power for a component...
Why choose a belt drive over a chain drive? The function of belt drive and chain drive is very similar. However, what are the advantages of belt drive over chain drive? Reduce maintenance requi...
The Cylinder Head Engine hood and sealing cylinder parts Components of engine cover and sealing cylinder (including water jacket, valve and cooling fin) are the installation basis of valve mech...
Cause analysis of cylinder sleeve wear The working environment of cylinder liner is very bad, and there are many reasons for wear. Under normal circumstances, due to construction reasons, normal wear ...
Type of common cylinder gasket Common cylinder gaskets include asbestos (non asbestos) rubber composite gasket, metal clad (copper clad iron clad) gasket, composite coating gasket, metal composite gas...
Tractor Problems and Solutions As a star machine in the farm, the tractor provides you with the power and versatility required to perform various agricultural and landscaping tasks. However, in order ...
What are the requirements for tractor starting operation (1)After the engine is started, it should idle at medium speed, preheat the engine first, check the operation and instrument readings, and star...
Causes and solutions of low engine oil pressure Reasons for low engine oil pressure: Oil pump wear, pressure limiting valve wear or foreign matters; Low oil storage; Oil or viscous for a long time dur...
What is the reason why the engine valve is not closed tightly? The following are the reasons for the untight valve closing: 1.The valve clearance is too small. The valve clearance must be adjus...
What is the reason for unstable engine speed? What about the solution? Usually, this is caused by the leakage of the intake system and valves, excessive scaling of the throttle valve and intake pipe, ...
